How To Clean Out A Torque Converter

How to Flush Debris From a Torque Converter

by Skip Shelton

Jupiterimages/Photos.com/Getty Images

A torque converter acts in an automatic transmission the fashion a clutch would in a manual transmission. Using loftier force per unit area fluid to couple the engine and transmission, the torque converter requires clean fluid to operate correctly. Small particles and debris from deterioration in the automatic transmission can forbid the torque converter from being fully efficient and may cause harm. Flushing the debris requires an substitution of transmission fluid. Mechanical dis-assembly of the torque converter is required when particles are also big to be suspended and removed through fluid substitution.

Flush Preparation

Footstep i

Park the vehicle on a level surface. Engage the parking restriction. Open the hood. Allow the manual to absurd for 30 minutes if the engine is hot.

Step 2

Determine the verbal transmission fluid capacity of your manual. The total transmission capacity will include the fluid contained in the torque converter. The data will exist bachelor in the vehicle's owner's manual. Purchase or acquire enough fluid to replace the full capacity, plus an additional two quarts.

Pace 3

Position a bucket or catch pan under the transmission cooling line. The transmission cooling line volition connect either to the radiator -- in dual core radiators -- or to a separate smaller radiator.

Step 4

Disconnect the transmission cooling line. Direct the fluid catamenia into the saucepan or catch pan. Secure the line to the take hold of pan, or take an assistant help.

Pull the dipstick from the automatic transmission fluid check tube.

Flush the Torque Converter

Step i

Kickoff the vehicle. Immediately place the transmission gearing in the "Neutral" position. Fluid will be expelled from the transmission cooling line at this time. Check to ensure the fluid is all the same draining into the catch pan.

Step ii

Place a funnel at the oral fissure of the transmission dipstick tube. Pour in transmission fluid at virtually the aforementioned rate fluid is beingness drained into the catch pan.

Step 3

Move the transmission through each of the gears when about iii quarters of the total fluid capacity of the transmission has been drained and replaced. Yous will need an assistant to proceed filling the manual during this process. One time the manual has motility through all the gears, including "Reverse," motility the transmission back to the "Neutral" position.

Step 4

Plow off the engine, once the total amount of transmission fluid has been exchanged, turn off the engine.

Footstep v

Reconnect the transmission cooling line. Restart the engine.

Use the dipstick to check the level of fluid in the manual. Add fluid as necessary. Drive the vehicle for approximately 5 miles. Recheck the fluid level.

References

Things You lot'll Need

• Bucket
• Small socket set
• Socket wrench
• Screwdriver
• Funnel

Writer Bio

Skip Shelton has been writing since 2001, having authored and co-authored numerous articles for "Disclose Journal." He holds a Available in Science in didactics and a Master of Business Administration with an emphasis in management from Northwest Nazarene University. Shelton besides operates a small automotive maintenance and role-replacement shop.

More Articles

Source: https://itstillruns.com/flush-debris-torque-converter-8015833.html

Posted by: robinsontheessale1962.blogspot.com

Share this post